Viper Rear Brake Caliper Cover Installation
Tools needed:
Your normal equipment to change a tire (jack, lug nut wrench) 7/64 allen wrench for socket head screws 5/16 socket or hand wrench for flex-loc nuts
Insert the short socket head screws into the end holes of the brake cover. Thread on a flex-loc nut and tighten. The middle holes will be used to attach the covers to the brake pad.
Safely jack up rear and remove rear wheel. The brake rotor, caliper, and brake pad will be easily visible.
Pass the long screws through the middle two holes of the cover and slide an aluminum tube over the screw.
Insert the ends of the screws into the brake pad holes. Thread on the flex-loc nuts and tighten. (View is from inside wheel well, looking up at caliper.)
When done, grasp brake cover and check for looseness.
All four screws should be firmly attached and rattle free. Repeat on other side.
Congratulations.
(Thanks Dave!)
Wish to purchase? Click here.
v1.0